arindam77 wrote:Seems you made a mistake, silicone is not to be injected while the spacers are in position.
You should have made like point soldering with silicone while the spacers are in position, around 1 foot apart, then let the points cure, then remove spacer, trim the excess silicone at the points soldered/ joined both inside and outside and then inject silicone along the whole seam.
And you should put the tape at narrower margin, so that less silicone is visible.
Now, i see why there was mess with silicone.
Anyway, it's the sump. Better luck next time. I will try to draw a image showing steps, if time permits.
Will the joints hold together? or should i redo them.